[Paraview] selected points change when clip plane changes

David E DeMarle dave.demarle at kitware.com
Fri Sep 14 07:33:12 EDT 2012


Apply the extract selection filter.

David E DeMarle
Kitware, Inc.
R&D Engineer
21 Corporate Drive
Clifton Park, NY 12065-8662
Phone: 518-881-4909


On Fri, Sep 14, 2012 at 6:46 AM, Zenker, Dr. Matthias
<Matthias.Zenker at erbe-med.com> wrote:
> Hi,
>
> I have observed a strange behavior: when I select points in a 3D geometry
> where the clip filter has been applied, and then change the position of the
> clip plane, the selected points jump to completely other positions. Is there
> an explanation for this behaviour? How can I make the points stay where they
> are?
>
> Thank you,
>
> Matthias
>
>
>
> _____________________________________________________________________
> ERBE Elektromedizin GmbH
> Firmensitz: 72072 Tuebingen
> Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
> Registergericht: Stuttgart HRB 380137
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>


More information about the ParaView mailing list