[Paraview] Inconsistent results with the stream trace filter

[Magician]

Hi Joseph,


I tried your data and got a result as yours.
Your data only includes Hex, Wedge, Tet and Pyramid,
but streamlines are stopped earlier.

Same as my polyhedral pipe sample, I applied Tetrahedralize filter
to your pipe source, and I could get valid streamlines.


Magician


> Pipe.tar.gz attached to the bug report below, in the form of an Ensight
> Case.  First extract the archive and to open in Paraview, use "All files
> (*)" when browsing and select the .encas, then select "EnSight Files".
> 
> 
> Regards,
> Joseph David Borġ
> http://www.jdborg.com
> 
> 
> On 12 October 2012 03:28, Yuanxin Liu <leo.liu at kitware.com> wrote:
> 
> > Hi,
> >    Is it possible for you to upload the data?  By the way, if the cell
> > type is polyhedron, then this is quite likely the same bug as this:
> > http://paraview.org/Bug/view.php?id=13442
> >
> > Leo
> >
> > On Thu, Oct 11, 2012 at 6:17 AM, Joe Borġ <mail at jdborg.com> wrote:
> >
> >> Hi guys,
> >>
> >> I've got an odd issue with the stream trace and stream trace custom
> >> source filters in Paraview (3.14.1 64bit).  No matter what settings I use,
> >> the traces die off very soon and some even carry on straight (even when
> >> there's no fluid).
> >>
> >> See the two screenshots I've got from Paraview.
> >>
> >> http://jdborg.com/images/paraview/pv_inlet.png
> >> http://jdborg.com/images/paraview/pv_outlet.png
> >>
> >>
> >> Not sure if this is a setting that's easy to miss or if it's more
> >> terminal.
> >>
> >> Thanks,
> >>
> >>
> >> Regards,
> >> Joseph David Borġ
> >> http://www.jdborg.com