[Paraview] How to get rpath set

David Partyka david.partyka at kitware.com
Wed Nov 9 13:55:59 EST 2011


This is where I look for answer to rpath related questions, I believe one
of the few variables in this wiki will do what you want.

http://www.vtk.org/Wiki/CMake_RPATH_handling

On Wed, Nov 9, 2011 at 1:48 PM, Cook, Rich <cook47 at llnl.gov> wrote:

> I know there is a religious answer to this, but I want to have rpath set
> in my binaries after install, for our osmesa backends.  I'm wrong and bad
> for this, I accept all blame and shame, but I want to do it anyhow.  The
> default Paraview install stubbornly insists on stripping all the rpaths out
> at install time, which is quite depressing.  Even worse, I know I've asked
> this before and I cannot find an answer in my archives or with Google.  :-(
> What would be the easiest way to do this?  Can I do this by setting a
> CMake variable?
> Thanks!
>
> --
> ✐Richard Cook
> ✇ Lawrence Livermore National Laboratory
> Bldg-453 Rm-4024, Mail Stop L-557
> 7000 East Avenue,  Livermore, CA, 94550, USA
> ☎ (office) (925) 423-9605
> ☎ (fax) (925) 423-6961
> ---
> Information Management & Graphics Grp., Services & Development Div.,
> Integrated Computing & Communications Dept.
> (opinions expressed herein are mine and not those of LLNL)
>
>
>
> _______________________________________________
> Powered by www.kitware.com
>
> Visit other Kitware open-source projects at
> http://www.kitware.com/opensource/opensource.html
>
> Please keep messages on-topic and check the ParaView Wiki at:
> http://paraview.org/Wiki/ParaView
>
> Follow this link to subscribe/unsubscribe:
> http://www.paraview.org/mailman/listinfo/paraview
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20111109/be861c35/attachment.htm>


More information about the ParaView mailing list