[Paraview] Exporting ICEM CFD Mesh to ParaView

[Mark Olesen]

On Mon, 2010-01-18 at 19:37 -0200, Rafael Castaneda wrote:
> Hi,
> 
> I'm trying to export a mesh generated in ICEM CFD to ParaView. I
> realized that I can export the mesh to Exodus II format and then open
> it with ParaView, but no information about the parts of the mesh is
> loaded, just the blocks. 
> 
> Any reader available to export geometry and mesh from ICEM CFD to
> ParaView ? I would like that the MultiBlockDataSet generated as result
> have information about the parts created in ICEM CFD.

Writing it as a Fluent mesh might work, but haven't tried it myself.

/mark


This e-mail message and any attachments may contain legally privileged, confidential or proprietary Information, or information otherwise protected by law of EMCON Technologies, its affiliates, or third parties. This notice serves as marking of its "Confidential" status as defined in any confidentiality agreements concerning the sender and recipient. If you are not the intended recipient(s), or the employee or agent responsible for delivery of this message to the intended recipient(s), you are hereby notified that any dissemination, distribution or copying of this e-mail message is strictly prohibited. 
If you have received this message in error, please immediately notify the sender and delete this e-mail message from your computer.