[Paraview] XY Plot question

Eric Allison eallison at desktopaero.com
Fri Oct 30 15:28:30 EDT 2009

Thanks for your replies. This example (from ensight) is somewhat ugly,  
but indicative of what I am after:



On Oct 30, 2009, at 11:29 AM, Marcus D. Hanwell wrote:

> On Friday 30 October 2009 14:18:03 Moreland, Kenneth wrote:
>> Uh... I don't think any of us have thought of that particular plot
>> configuration.  Someone at Kitware should make sure that this design
>> consideration filters its way to Marcus.
>> -Ken
>> On 10/28/09 10:31 PM, "Eric Allison" <eallison at desktopaero.com>  
>> wrote:
>> Apologies if this is a dumb question - I'm investigating Paraview  
>> as a
>> replacement for Tecplot, and one of the things I'd really like to do
>> is take Cp slices on CFD geometries. I figured out how to make an XY
>> plot of the slice data, but can't for the life of me figure out how  
>> to
>> reverse the Y axis so that Cp displays the way aero people like to  
>> see
>> it. (smaller numbers at the top, larger at the bottom).
>> Any help would be appreciated.
> I saw the message, what I am doing should be able to accommodate  
> this type of
> layout, I will test this out later just to confirm. So something  
> akin to
> setting the minimum Y value to 5.0 and the maximum Y value to 0.0?
> Any example plots you may be able to point out would help me.
> Marcus
> -- 
> Marcus D. Hanwell, Ph.D.
> R&D Engineer, Kitware Inc.
> (518) 881-4937

More information about the ParaView mailing list