[Paraview] Baffled by "floating point exceptions" in ParaView 3.6.1
randall.hand at gmail.com
Thu Jul 30 09:52:18 EDT 2009
I was unable to compile 3.4 against these libraries, compilation would fail
with errors in the Python libraries about "-fPIC".
I'll try again without MPI & Python, and get back with you.
On Thu, Jul 30, 2009 at 8:47 AM, Berk Geveci <berk.geveci at kitware.com>wrote:
> Can you try compiling without Python and MPI? Also, can you try with
> Mesa? I am guessing some system library is causing this problem but
> without a stack trace, it will be trial-and-error to find out which.
> Also, do older versions work with the same libraries?
> On Thu, Jul 30, 2009 at 9:43 AM, Randall Hand<randall.hand at gmail.com>
> > I've compiled ParaView 3.6.1 three times so far, and every time it
> > successfully but when I attempt to run it, it dies with "Floating point
> > exception".
> > I'm compiling it on a Linux system (RHEL4), and linking against MPI
> > 1.2.8) and python (2.5.1). I'm using cmake 2.6.4 . Is there some known
> > problem here?
> > I compiled Paraview in "Debug" mode, but a backtrace doesn't show
> > but question marks.
> > --
> > Randall Hand
> > Visualization Scientist
> > http://www.yeraze.com
> > http://www.vizworld.com
> > _______________________________________________
> > Powered by www.kitware.com
> > Visit other Kitware open-source projects at
> > http://www.kitware.com/opensource/opensource.html
> > Please keep messages on-topic and check the ParaView Wiki at:
> > http://paraview.org/Wiki/ParaView
> > Follow this link to subscribe/unsubscribe:
> > http://www.paraview.org/mailman/listinfo/paraview
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the ParaView