[Paraview] a minor problem with Sources->Point Source

[Takuya OSHIMA]

Hi,

This time a minor problem with Source->Point Source. Select
Sources->Point Source, enter non-origin point e.g. (1 2 3) to Point,
enter either Number of Points other than 1 or Radius other than 0,
click Apply. Then the Point is reset to (0 0 0). However if I re-enter
the point, this time the point coordinates are set as expected. Not a
big problem but would be nice to have it fixed?

Takuya OSHIMA, Ph.D.
Faculty of Engineering, Niigata University
8050 Ikarashi-Ninocho, Nishi-ku, Niigata, 950-2181, JAPAN