[Paraview] Ghost cells for standalone Paraview

[Moreland, Kenneth]

If you are not running in parallel, you do not need ghost cells.  If necessary, just run the Clean to Grid filter to restore connectivity.

-Ken


On 12/2/08 7:10 AM, "Fabian Wein" <fabian.wein at lse.e-technik.uni-erlangen.de> wrote:

Hi,

To close my isosurfaces of my unstructured grid I need ghost cells.
I found that D3 is capable of doing this but I use a standalone ParaView.

What can I do? Shall I write a python filter?

Thanks,

Fabian
_______________________________________________
ParaView mailing list
ParaView at paraview.org
http://www.paraview.org/mailman/listinfo/paraview




   ****      Kenneth Moreland
    ***      Sandia National Laboratories
***********
*** *** ***  email: kmorel at sandia.gov
**  ***  **  phone: (505) 844-8919
    ***      web:   http://www.cs.unm.edu/~kmorel

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.paraview.org/pipermail/paraview/attachments/20081202/5a846031/attachment.htm>