[Paraview] mpirun of paraview

[Eric]

Hello, 
   
  I tried to run paraview which was compiled with mpich. I noticed that cpu usage on paraview data servers (pvserver) is always around 99% even though no data processing at all. Only the first pvdataserver's cpu usage was reasonable(where I started the mpirun command).
   
  Why did that happen? Does that mean paraview is not working properly on all paraivew data servers.
   
  I have four nodes to be used as paraview data server.
  Command I used on the first paraview data server: host1
  # mpirun -np 4 -machinefile hostsfile /opt/paraview path/pvserver
   
  Commad I used on client node: client1
  #//opt/paraview path/pvclient -sh=host1
   
  After these commands, message "client connected" was showed on host1 and paraview GUI was successfully opened on client node.
   
  Did I do something wrong?
   
  BTW, I tried to start pvdataserver, pvrenderserver and pvclient on different server,
  On client node, I run command:
  #pvclient -sh=host1 -rsh=host5 
  Only pvdataserver reported "client connected", pvrenderserver was waiting with no response. What should I do with this?
   
  Thanks.
  Eric

		
---------------------------------
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://public.kitware.com/pipermail/paraview/attachments/20060417/371ab603/attachment.htm