[Paraview] polygon offset

[Dominik Szczerba]

Thanks a lot, yes, still however it is far from what I used to get with 
my own small codes, but that might be an issue for VTK mailing list 
instead. Still, it looks a bit like a dead-end to me (where to put it?).
bye
Dominik

Wylie, Brian wrote:
> Okay I know this is a not a 'solution' but for a quick fix set the line
> width to '2' instead of '1'. It will look much better. :)
> 
>   Brian Wylie - Org 9227
>   Sandia National Laboratories
>   MS 0822 - Building 880/A1-J
>   (505)844-2238 FAX(505)845-0833                       
>        ____                  _    __
>       / __ \____  _________ | |  / (_)__ _      __ 
>      / /_/ / __ `/ ___/ __ `/ | / / / _ \ | /| / /
>     / ____/ /_/ / /  / /_/ /| |/ / /  __/ |/ |/ /
>    /_/    \__,_/_/   \__,_/ |___/_/\___/|__/|__/
> 
>                                     Unleash the Beast
>  
> 
> 
>>-----Original Message-----
>>From: paraview-bounces+bnwylie=sandia.gov at paraview.org 
>>[mailto:paraview-bounces+bnwylie=sandia.gov at paraview.org] On 
>>Behalf Of Dominik Szczerba
>>Sent: Tuesday, December 06, 2005 9:26 AM
>>To: paraview at paraview.org
>>Subject: [Paraview] polygon offset
>>
>>Hello,
>>Does Paraview support OpenGL polygon offset extension? If I 
>>try to visualize e.g. a tet mesh with edges (extract edges, 
>>shrink tets) the result looks very bad. Does VTK offer it at 
>>all? Is it at all possible using the VTK's filter philosophy?
>>regards,
>>Dominik
>>--
>>Dominik Szczerba, Dr.
>>ETZ C110 CO-ME/BIWI CH-8092 Zurich
>>http://www.vision.ee.ethz.ch/~domi
>>_______________________________________________
>>ParaView mailing list
>>ParaView at paraview.org
>>http://www.paraview.org/mailman/listinfo/paraview
>>
> 
> 

-- 
Dominik Szczerba, Dr.
Computer Vision Lab CH-8092 Zurich
http://www.vision.ee.ethz.ch/~domi