MantisBT - ParaView
View Issue Details
0009425ParaViewBugpublic2009-08-14 18:262016-08-12 09:57
Alan Scott 
Utkarsh Ayachit 
normalminoralways
closedmoved 
 
 
Sandia
0009425: Center lines don't line up properly against a plane
I think this is a good example of a bug that I have been seeing on and off for a long time. This bug is also not a driver issue - I just tested it on thunderbird, which uses mesa.

Open file centerCrossBug (attached). Just rotate the 2d plane around, and the center cross will appear and disappear.

Replicated local server and remote server, hardware rendered and mesa rendered, Linux and XP. Trunk.

If possible, it would be nice to have this fixed for 3.6.2, but lets slip it to 3.8 if it is real hard.
No tags attached.
Issue History
2009-08-14 18:26Alan ScottNew Issue
2009-08-17 12:52Alan ScottNote Added: 0017149
2011-02-18 13:57Utkarsh AyachitAssigned To => Utkarsh Ayachit
2011-02-18 13:57Utkarsh AyachitStatusbacklog => tabled
2011-02-18 13:57Utkarsh AyachitTarget Version3.8 => 4.0
2011-09-01 10:56Utkarsh AyachitProject => Sandia
2016-07-13 20:27Alan ScottNote Added: 0036435
2016-08-12 09:57Kitware RobotNote Added: 0037682
2016-08-12 09:57Kitware RobotStatusbacklog => closed
2016-08-12 09:57Kitware RobotResolutionopen => moved

Notes
(0017149)
Alan Scott   
2009-08-17 12:52   
File was not downloaded correctly. It is very close to the size limit. I will push it to Kitware manually.
(0036435)
Alan Scott   
2016-07-13 20:27   
Just tested, and there are stitching issues. However, the line itself isn't coming or going.
(0037682)
Kitware Robot   
2016-08-12 09:57   
Resolving issue as `moved`.

This issue tracker is no longer used. Further discussion of this issue may take place in the current ParaView Issues page linked in the banner at the top of this page.